I have to admit that I am ready for a new project. However, I don't want the remaining stockings to join the stacks of unfinished projects in the craft room.
The thought briefly crossed my mind that if they happened to land in the trash when I was cleaning up the loft, I wouldn't have to finish them nor would they wind up on the unfinished projects list. I couldn't do it. I have four left to stuff, nine left to sew shut, and eight left to do the final decorating on.
Hmmm, that is almost depressing.
On the plus side, though, tonight I managed to finish seven more ornaments.
I truly am having fun adding the bling.
Although, I think I had even more fun shopping for new bling...but that is a whole different story!
So many projects....so little time. So many more projects to start.
Wednesday, September 28, 2011
Tuesday, September 20, 2011
Christmas Stocking Ornaments Part 2
This is part 2 of the Christmas stocking ornaments.
I now have, oh, almost 25 ornaments in various stages of completion. I definitely went overboard. Just a little.
Once the stockings were turned inside out, it was time to start stuffing. Once again, the small opening made it a bit difficult.
And, the general shape of the ornament also made it a fun challenge to stuff...
Between the small opening and the heel area, stuffing the toe meant pulling out the same tool I used to help turn the ornament right-side out.
Eventually, though, I did get the stocking stuffed. I was surprised at how much stuffing each stocking actually took.
Once stuffed, it was time to start hand sewing.
After a couple of attempts, I finally settled on a way to sew the top shut while adding the loop.
As an aside, the first one I made, I didn't think about putting in the loop to hang until I was almost finished decorating the stocking. That approach definitely did not work.
The approach that did work was to choose the trim that I wanted to use for the loop, which for this particular ornament was a bit of gold elastic. Once again, each ornament is unique--I didn't use any particular measurement for the loop. Instead, I just put the trim in the shape I wanted, added about a half inch, and cut. Once cut, I knotted the ends.
After getting the cord ready, I made sure that the raw edges were tucked into the stocking. Then, I placed the knotted end into the top of the stocking.
And, then I started sewing, being really careful to put a lot of stitches around the cord, including in between the two cord ends. I definitely don't want the cord to slip out of the stocking. The finished edge is kind of flat, but it will get covered up.
Next, I selected the trim, cut it to fit, and sewed it on.
I can either leave it like this or add beads or other findings.
I now have, oh, almost 25 ornaments in various stages of completion. I definitely went overboard. Just a little.
Once the stockings were turned inside out, it was time to start stuffing. Once again, the small opening made it a bit difficult.
And, the general shape of the ornament also made it a fun challenge to stuff...
Between the small opening and the heel area, stuffing the toe meant pulling out the same tool I used to help turn the ornament right-side out.
Eventually, though, I did get the stocking stuffed. I was surprised at how much stuffing each stocking actually took.
Once stuffed, it was time to start hand sewing.
After a couple of attempts, I finally settled on a way to sew the top shut while adding the loop.
As an aside, the first one I made, I didn't think about putting in the loop to hang until I was almost finished decorating the stocking. That approach definitely did not work.
The approach that did work was to choose the trim that I wanted to use for the loop, which for this particular ornament was a bit of gold elastic. Once again, each ornament is unique--I didn't use any particular measurement for the loop. Instead, I just put the trim in the shape I wanted, added about a half inch, and cut. Once cut, I knotted the ends.
After getting the cord ready, I made sure that the raw edges were tucked into the stocking. Then, I placed the knotted end into the top of the stocking.
And, then I started sewing, being really careful to put a lot of stitches around the cord, including in between the two cord ends. I definitely don't want the cord to slip out of the stocking. The finished edge is kind of flat, but it will get covered up.
Next, I selected the trim, cut it to fit, and sewed it on.
I can either leave it like this or add beads or other findings.
Monday, September 19, 2011
Christmas Stocking Ornaments
I hadn't realized that it had been so long since my last posting. My crafting has been scattered and unfocused this past month, which is most likely the reason for the lack of posts. I've done some crocheting, put together a quick quilt top, worked on some luminaries, and most recently, worked on a bunch of Christmas ornaments for our Etsy shop.
While working on the Christmas ornaments, I've taken some photos along the way, and tonight I'm taking a break from sewing the ornaments to list some on our Etsy shop and start working on the blog again.
The Christmas ornaments that I am working on right now are small stuffed Christmas stockings, like the one here on the right.
I'm not entirely sure what started me on this kick, but I have definitely had fun with it. Each ornament is completely unique.
I start each one by placing the right side of the fabric together (and so that I don't waste fabric), I've been ironing a crease about 3 inches from the edge of the fabric.
Once the right sides were together, I free-handed the sewing lines for each stocking on the back side of the fabric.
Hmmm, note to self: using black fabric was probably not a great idea for the photos!
I tended to draw four or five stockings in a row, and I reversed them so that I would save a little bit of fabric.
Once drawn, I started sewing along the lines that I had drawn.
Eventually, I had a whole row of little sewn stockings:
Once I had a row of stockings, I cut about an eighth of an inch from the sewing line. I soon had a whole stack of stockings!
I may have gone a bit overboard...
Next came the fun of trying to turn these right-side out.
Fortunately, I learned from making the birds and pulled out the right tool for the job...
I soon had a whole stack turned right-side out.
Up next: finishing the stockings.
While working on the Christmas ornaments, I've taken some photos along the way, and tonight I'm taking a break from sewing the ornaments to list some on our Etsy shop and start working on the blog again.
The Christmas ornaments that I am working on right now are small stuffed Christmas stockings, like the one here on the right.
I'm not entirely sure what started me on this kick, but I have definitely had fun with it. Each ornament is completely unique.
I start each one by placing the right side of the fabric together (and so that I don't waste fabric), I've been ironing a crease about 3 inches from the edge of the fabric.
Once the right sides were together, I free-handed the sewing lines for each stocking on the back side of the fabric.
Hmmm, note to self: using black fabric was probably not a great idea for the photos!
I tended to draw four or five stockings in a row, and I reversed them so that I would save a little bit of fabric.
Once drawn, I started sewing along the lines that I had drawn.
Eventually, I had a whole row of little sewn stockings:
Once I had a row of stockings, I cut about an eighth of an inch from the sewing line. I soon had a whole stack of stockings!
I may have gone a bit overboard...
Next came the fun of trying to turn these right-side out.
Fortunately, I learned from making the birds and pulled out the right tool for the job...
I soon had a whole stack turned right-side out.
Up next: finishing the stockings.
Subscribe to:
Posts (Atom)
The Turf Makes a Huge Difference
I'm finally caught up on older posts. I took this photo this morning, just after the front lawn had been put in. I'm loving it.
-
Back in July, we replaced three windows, which led to replacing the curtains in the kitchen and dining room. Amazingly enough, we quickly...
-
Last weekend I had to go get some more thread for the machine quilting. I decided to pick up some satin binding for the quilt. Normally, I...
-
Sometimes, we see things (that the builder goes ahead and fixes) that just make us twinge. On this particular day, it was the downspouts.....